AllMotion: High-current intelligent Stepper Motor Controller/Driver with Encoder Feedback EZHR23ENHC
The EZStepper was
designed to allow the rapid implementation of stepper motor solutions in
products requiring automation.
Measuring only 2.25 " x 2.25" " (57mm x
57mm), the fully intelligent stepper motor Controller + Drivers are designed to
be bolted onto the back of the stepper motors that they control. A single 4
wire bus, containing 2 power wires and two communications wires, links up to 16
such stepper motor controllers in a daisy chain. Commands can be issued from
any serial terminal program (such as HyperTerminal) or from the EZStepper Windows
application.
The Commands are
intuitive and simple. For example, the command A10000 will move the stepper
motor to Absolute position 10000. (This communications protocol is compatible
with devices that use the Cavro DT or OEM protocol.)
The EZStepper is also capable of stand-alone operation with
no connection to a PC. It can be set to execute a preset string of commands
upon power up (i.e., only power is required in this mode). The Commands include
nested loops and execution halt pending a switch closure, which is useful in
stand-alone applications.
The EZHR23ENHC Stepper Motor Controller will work with any
stepper motor that is 5 " diameter or smaller. Our Starter
Kits enable a first time user to make a Stepper Motor move
intelligently in less than half an hour.