Powered By E-MOTION
* In overseas warehouse, about 1 week lead time for this Model.
Delta Tau: Stack Board (ACC-2P)
ACC-2P
High-speed-communications/digital-I/O board (Requires at least one of Opt 1A, 1B, 2, or 3)
Part No.:300-603672-10x
OPT1AOption 1A: USB Interface
480 Mbit/sec USB 2.0 interface
Part No.:31A-603672-OPT
Provides a 12 Mbit/sec USB interface allowing USB communications with the PMAC2A PC/104 motion controller.
OPT1B
100 Mbit/sec Ethernet interface & 480 Mbit/sec USB 2.0 interface
Part No.:31B-603672-OPTOPT2 Option 2: DPRAM CircuitryOn-board 8K x 16 dual-ported RAM for USB, Ethernet or PC/104 port (OPT-2A on base board).
Provides an 8K x 16 dual-ported RAM for USB, Ethernet or PC/104 ports on board of the Acc-2P communications board. If using for USB or Ethernet communications, Acc-2P-Opt-1A or Acc-2P-Opt-1B must be ordered. If used for PC/104-bus communications, PMAC2A PC/104 Option-2A must be ordered. The key component installed with this option is U17.
OPT3Option 3: I/O Ports
ACC-2P Option 3 provides the following ports
• Multiplexer Port: To be used with PMAC ACC-34x type boards.
• TTL I/O Port: this port provides 16 lines at 5 VDC levels.
• Handwheel port: this port provides 2 extra channels, each jumper selectable between encoder input or pulse output.
Part No.:303-603672-OPT
Provides the following ports on the Acc-2P communications board for digital I/O connections.
Multiplexer Port: this connector provides eight input lines and eight output lines at TTL levels. When using the PMAC Acc-34x type boards these lines allow multiplexing large numbers of inputs and outputs on the port. Up to 32 of the multiplexed I/O boards may be daisy-chained on the port, in any combination.
I/O Port: this port provides 16 general-purpose digital I/O lines at TTL levels and these can be configured as all inputs, all outputs or eight inputs and eight outputs.
Handwheel port: this port provides two extra channels, each jumper selectable between encoder input or pulse output.